Prep Your RV For Spring in 10 Easy Steps

It’s that time of year again!

Prep Your RV For Spring in 10 Easy Steps

Prep Your RV For Spring in 10 Easy Steps

With temperatures rising now is the time to take your RV out of winter hibernation.

Thoroughly inspect the RV and prepare it for that first road trip or weekend getaway to your favorite camping destination.

De-Winterization

If you stored your RV in preparation for freezing temperatures, special attention needs to be given to the water system. Drain and flush the antifreeze from all water sources, including water heater and toilet.

After flushing, sanitize the freshwater tank. Let stand for at least 6 hours. Drain the water tank, water lines, and water heater. Flush the freshwater system until any bad taste and odor is gone.

Leave all faucets closed for 48 hours and check for any water leaks or required pump repairs.

Check Batteries

Columbia Sun RV Resort, Kennewick, Washington © Rex Vogel, all rights reserved

Prep Your RV For Spring in 10 Easy Steps. Camping at Columbia Sun RV Resort, Kennewick, Washington © Rex Vogel, all rights reserved

RV batteries can give trouble after long periods of storage without proper charging. Testing the batteries will ensure that any problems will be addressed prior to travel. If there is corrosion on the battery terminals, it’s recommended that you clean and protect them from further corrosion. Use baking soda and water or commercial cleaners and acid neutralizers.

Exterior Maintenance

Wash the RV and thoroughly inspect entire rig for anything in need of repair or replacement. Start with the roof. Always take special care when walking on any wet surface especially when height is involved. Check for cracks or other deterioration that may have occurred, especially in the caulking around the vents, seams, and antennas. Also inspect vent lids and sun lights. Check the awnings and slide toppers for any holes, tears, and mold.

​Inspect Tires

Inspect all tires prior to each trip to make sure there are no unexpected delays along the way. Check the date of manufacture from the D.O.T code that is located on the outside tire sidewall. RV tires often age out before they wear out. During your inspection, check for cracks, cuts, bubbles, and uneven or abnormal wear. Make sure all tires are inflated to the correct pressure. Check your RV manufacturer’s label or consult the tire manufacture’s load and inflation tables.

Midtown RV, Newmar and Airstream dealer in Penticton, British Columbia © Rex Vogel, all rights reserved

Prep Your RV For Spring in 10 Easy Steps. When in doubt, check with a qualified service technician. Midtown RV, Newmar and Airstream dealer in Penticton, British Columbia © Rex Vogel, all rights reserved

Propane System

Check the propane system. Before opening the valve, thoroughly inspect the regulator, fittings, and rubber hoses, and LP-tank for any corrosion or cracks. LP-gas regulators do not last forever. When in doubt, check with a qualified service technician.

Once the propane system has been properly tested, service all propane operating appliances. Check for debris, rust, and clean all appliances thoroughly. Also be sure to check electrical connections for corrosion as these could be a potential fire hazard.

Anything you aren’t comfortable doing yourself or have questions or concerns about, consult the service department at your RV dealer.

Generator

Prior to starting the generator check for fuel or oil leaks, check the oil level, and examine the exhaust system to ensure there are no leaks.

Discover Okanagan Valley © Rex Vogel, all rights reserved

Now, let’s go RVing to the beautiful Okanagan Valley in British Columbia. © Rex Vogel, all rights reserved

Start the generator and check necessary functions. One of the primary problems with generators comes from lack of use. Fuel often breaks down and gets gummy. Moisture can build up resulting in damage. Check manual for maintenance schedule.

Dump Hoses

Check your sewer hoses for any tears before using. Sewer hoses have a limited life expectancy and should be replaced as needed.

Waste Tank Valve

Ensure the waste tank valves are functioning properly by working the handles in and out in small increments. (Make sure tank is empty before doing this!) Valve seals can dry out over time making them stick.

Check Lights

Do a visual inspection of all interior and exterior lights and replace bulbs as needed.

Safety Detectors & Monitors

Today’s RVs come from the factory with a number of detectors pre-installed to detect dangerous circumstances and prevent personal harm to their occupants. Smoke, carbon dioxide, and LP gas detectors need to be checked annually—and have a fresh set of batteries installed.

Now, Let’s Go RVing!

Worth Pondering…

Remember, safety first and happy RVing.

Leave a Reply